45-Degree Offset Box End Wrench Set, 8-Piece (1/4 - 1-1/4 in.) Quantity:1 The bits are made with

The bits are made with tight tolerances for a secure fit in small screws

5 HRC for use on impact wrenches • Corrosion-Resistant – The socket is coated with a manganese phosphate finish to resist corrosion • Two Size Markings – The size is marked with a high-visibility laser marking and a permanent stamped marking that won't rub off • Friction Ring or Detent Pin Anvils – Smooth walls inside the drive end and a detent pin hole make the bit sockets compatible with both drive tool anvil types

• Precise Bit Geometry – The bit tip is machined to precise tolerances • Optimal Two-Piece Design – We use separate steel alloys and processes for the bit and socket

Part Number: 75C250HCSSS/316

Part Number: BIT-DWDCO25/32

45-Degree Offset Box End Wrench Set, 8-Piece (1/4 - 1-1/4 in.) Quantity:1 The bits are made withGenerous Offset Each end is offset 45 degrees, creating plenty of clearance for your fingers and allowing an easy reach over and around obstructions 12 Point Openings Doubling the access angles of 6 point wrenches, these 12 point openings make it easier to work in tight spaces Non Rounding Geometry To prevent damaging roundoff, the geometry of each opening contacts and applies force to the flat sides of fastener heads rather than the corners No