Standard Spring Probe (Electro-mechanical) Connection Hardware & Accessories *Input for scrap count (optional)

*Input for scrap count (optional)

This is a chassis mount version of the connector used on the QDP kit board

The ShopFloorConnect Machine Interface (SMI 2) is the fastest way to connect virtually any machine to the ShopFloorConnect Machine Monitoring Software

This long range 8 mm diameter shielded proximity sensor is Normally Open

This inductive proximity sensor has a Normally Closed operating mode

Standard Spring Probe (Electro-mechanical) Connection Hardware & Accessories *Input for scrap count (optional)The Standard Spring Probe is one of the oldest and most versatile sensors used for die protection. Its operation is simple: The spring is connected to a terminal that is wired to a die protection input. The whole assembly is contained in an insulated plastic block. When a piece part, the coil stock, or tooling contacts the spring, it provides an electrical path to earth ground, which is detected by the die protection control. The Standard Spring Probe